How to Wear and Connect Your YESOUL Heart Rate Chest Strap

The YESOUL Heart Rate Chest Strap helps you monitor your heart rate during workouts, allowing you to keep track of your exercise performance.

To use the heart rate chest strap, please follow the steps below:

1. Wear the chest strap correctly to activate it.
2. Connect the chest strap through the YESOUL FITNESS App or your treadmill's built-in screen, depending on your device model.

1. How to Wear the Heart Rate Chest Strap Correctly

Please follow these steps to put on your heart rate chest strap:

Step 1: Moisten the electrode areas

Use a little clean water to moisten the two black rubber electrode areas on the inside of the chest strap. This helps ensure good contact with your skin.

Step 2: Position and adjust the chest strap

Adjust the strap length and fasten it comfortably around your chest, just below your pectoral muscles.

Make sure the moistened electrode areas are in close contact with your skin. The strap should fit snugly without feeling too tight.

Step 3: Attach the heart rate monitor

Attach the heart rate monitor module to the clips on the chest strap.

Please pay attention to the left and right positions:

• L (Red Label): Place it on your left side.
• R (Blue Label): Place it on your right side.

When worn correctly, the red L label should be on your left, and the blue R label should be on your right.

Once worn correctly, the chest strap will be activated and ready to connect.

2. How to Connect the Heart Rate Chest Strap

The connection method depends on your YESOUL equipment model. Please follow the instructions for your device below.

Option A: Connecting via the YESOUL FITNESS App

Applicable models:

• G1M Series Exercise Bikes
• T3S Series Treadmills
• J1M PLUS
• R1M PLUS
• S3

Please follow these steps:

Step 1: Open the YESOUL FITNESS App, select a class, and start your workout.

Step 2: Tap the Heart Rate Chest Strap icon on the workout screen.

Step 3: Wait for searching for nearby heart rate devices.

Step 4: Select YESOUL HRM 1 from the device list.

Step 5: Tap YESOUL HRM 1 to complete the connection.

Your heart rate data should now be displayed during your workout.

Option B: Connecting via the Treadmill's Built-in Screen

Applicable models:

• T5 MAX
• T5 ULTRA

Please follow these steps:

Step 1: Make sure the heart rate chest strap is worn correctly and activated.

Step 2: Turn on your treadmill's built-in screen.

Step 3: Tap the heart rate icon in the top-right corner of the screen.

Step 4: Search for YESOUL HRM 1 in the available device list and select it to connect.

Once connected, your heart rate should be displayed on the treadmill screen during your workout.

3. Troubleshooting: Cannot Connect or Find the Bluetooth Device

If you cannot connect to the heart rate chest strap or cannot find YESOUL HRM 1 in the Bluetooth device list, please try the following:

a. Check for existing Bluetooth connections

If the heart rate chest strap is already connected to another device, it may not be available for a new connection. Please turn off Bluetooth on other family members' phones or disconnect the chest strap from any previously connected devices, then try searching and connecting again.

b. Check the battery level

If the heart rate chest strap cannot connect, please check its remaining battery level. If the battery is low, charge the device before trying to connect again.