How to Fix a Dislodged Ball Head Elastic Pin on R1M PLUS

Tools Required

1. 13mm open-end wrench

2. Tweezers / pliers

Step 1 – Remove Screws

Use a 13mm open-end wrench to hold the screws and turn them counterclockwise until they can be fully removed.

For detailed guidance, please refer to the video:
Step 1 Operation Video

Step 2 – Assemble Components

Follow the steps shown in the video below to assemble all components correctly.
You may use tweezers/pliers if needed to assist with the assembly.

Step 2 Assembly Video

Step 3 – Install Assembled Components

Refer to the following video to install the assembled components into their designated positions:

Step 3 Installation Video

Tip

• It is recommended to apply a small amount of glue to the areas indicated by arrows in the video to enhance stability and prevent the pin from loosening again.

Need Help?

If you are unable to complete the steps above,  please submit a service ticket to get support from our customer service team. You can submit your request here: Submit a service ticket