How to Perform Resistance Calibration on Your Bike

To ensure your bike’s resistance system works accurately, you can perform a resistance calibration. Follow the steps below carefully.

Watch the full calibration video here:
Resistance Calibration Video

Step-by-Step Instructions

1. Connect the bike and start a course
   • Begin pedaling as if you are riding normally.
2. Open the cover of the control board
   • Locate the electronic control board inside your bike.
3. Set the resistance to maximum
   • Adjust the resistance so it is about 3–5 mm from the flywheel.
4. Press buttons A and B simultaneously
   • Hold both buttons until both lights on the control board turn on.
5. Long press button B
   • The green light will turn off.
6. Adjust the resistance to minimum
7. Long press button A
   • The red light will start flashing.

 It is best to complete the entire calibration process within one minute for optimal results.